moodlite

moodlite => moodlite Software => Topic started by: akku3D on February 28, 2019, 09:14:41 PM

Title: Need help with initial wifi
Post by: akku3D on February 28, 2019, 09:14:41 PM
Hello,

I successfully uploaded the sketch and then the webserver files.
After a restart of the ESP it will not build a new wifi.

What's wrong here and what else can I try?
Title: Re: Need help with initial wifi
Post by: akku3D on March 01, 2019, 08:42:17 AM
Following shows the serial monitor:
Title: Re: Need help with initial wifi
Post by: darrenp on March 02, 2019, 11:08:48 AM
I was having a similar issue, I think the eeprom needs resetting.

Around about line 550, there is a command eraseEEPROM(). Uncomment that, flash the sketch to the arduino, watch it boot and it should say something like eeprom erased. (don't uncomment the eraseSPIFFS() line, tho you can but you'd have to re-upload the data too)

Once thats done, (leave it a few minutes) then recomment that line in and flash the sketch again. Hopefully it will boot up without all the ??????? in the output.

May need an extra reset once its put the defaults into eeprom.

HTH.
Title: Re: Need help with initial wifi
Post by: akku3D on March 02, 2019, 04:37:33 PM
Thank you darrenp.
This was the right solution.