News

moodlite - Coming soon


Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - SimonSplat

Pages: 1
1
moodlite Electronics / Re: I'm stuck at 5 tiles.
« on: June 05, 2019, 02:40:13 PM »
As per Telanis post I managed to get mine working as below:

I had this issue but managed to fix it by changing the following code:

Code: [Select]

// --- Uncomment to reset ---
// Erase EEPROM
//eraseEEPROM();
// Erase SPIFFS
//eraseSPIFFS();

to

Code: [Select]
// --- Uncomment to reset ---
// Erase EEPROM
eraseEEPROM();
// Erase SPIFFS
eraseSPIFFS();

Then uploading both the firmware (Upload button) and then the SPIFFS/Sketch (Tools -> ESP8266 Sketch Data Upload)

After setting the code BACK to the original (with the lines commented out as in the first code excerpt) re-uploading both firmware and SPIFFS/Sketch as above.

I had both the USB plugged in as well as the DC power (not sure this makes any difference) and after doing the wifi settings can change the config in the web interface and the values persist and can use more than 1 tile/3 LED's

YMMV!

SimonSplat

2
moodlite Electronics / Re: Issue with V3 only 3 LEDS
« on: June 05, 2019, 02:39:22 PM »
I had this issue but managed to fix it by changing the following code:

Code: [Select]

// --- Uncomment to reset ---
// Erase EEPROM
//eraseEEPROM();
// Erase SPIFFS
//eraseSPIFFS();

to

Code: [Select]
// --- Uncomment to reset ---
// Erase EEPROM
eraseEEPROM();
// Erase SPIFFS
eraseSPIFFS();

Then uploading both the firmware (Upload button) and then the SPIFFS/Sketch (Tools -> ESP8266 Sketch Data Upload)

After setting the code BACK to the original (with the lines commented out as in the first code excerpt) re-uploading both firmware and SPIFFS/Sketch as above.

I had both the USB plugged in as well as the DC power (not sure this makes any difference) and after doing the wifi settings can change the config in the web interface and the values persist and can use more than 1 tile/3 LED's

YMMV!

SimonSplat

3
moodlite Electronics / Re: Only 3 leds light up
« on: June 05, 2019, 02:39:01 PM »
I had this issue but managed to fix it by changing the following code:

Code: [Select]

// --- Uncomment to reset ---
// Erase EEPROM
//eraseEEPROM();
// Erase SPIFFS
//eraseSPIFFS();

to

Code: [Select]
// --- Uncomment to reset ---
// Erase EEPROM
eraseEEPROM();
// Erase SPIFFS
eraseSPIFFS();

Then uploading both the firmware (Upload button) and then the SPIFFS/Sketch (Tools -> ESP8266 Sketch Data Upload)

After setting the code BACK to the original (with the lines commented out as in the first code excerpt) re-uploading both firmware and SPIFFS/Sketch as above.

I had both the USB plugged in as well as the DC power (not sure this makes any difference) and after doing the wifi settings can change the config in the web interface and the values persist and can use more than 1 tile/3 LED's

YMMV!

SimonSplat

Pages: 1

SMF spam blocked by CleanTalk