News

moodlite - Coming soon


Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bertybassett

Pages: 1
1
moodlite Design / Re: modified "tile bottom"
« on: September 06, 2019, 10:34:33 PM »
who that is much better, when I increased the print times the post would always snap off.

I will try your tiles tomorrow

2
thanks for the kind words.  Turn out the bar going across the unit holding the hold end was loss and had a bit of play causing shakes and the tiles to be weak on the legs for the lights.  Once the bar was tighter up.  The tiles printed ace.

so far I have managed to printer 7 bottom tiles.

I changed infill to 7% and speed to 75 and infill speed to 150 and then I get a print time of 7 and 1/2 hours.

3
9 hours later and I found that I printed it up side down  :-[ :-[ :-[

In Cura I needed to flip the STI over, printing again lets see what happens in 9 hours time.

4
What is everyone using?  I really only want 1 power lead and  20 to 25 tiles at max???  Worried about the servo wire amp limits

5
moodlite Chitchat / Re: Attaching Them Together
« on: August 14, 2019, 07:22:51 PM »
Your STI files on thingverse look much easier to print vs the official tiles.  Did you get around to printing them?

6
looks like I managed to make it fit by squeezing a few more mm from the bed. :-\ :-\ :-\

7
looks like I am going to have to reduce the size by 3% because my print bed is too small?  Do you think this will be an issue?

8
Anyone got any good recommendations for printing on a Ender 3 using Cura 4.2?  I am using the stock settings and PLA and get good results with the Benchy boat.

Hoping to get good results not he moodlites too.


Pages: 1

SMF spam blocked by CleanTalk