moodlite - Coming soon

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - gonzo

Pages: 1
moodlite Chitchat / Cut down on printing time with a bigger nozzle
« on: July 17, 2019, 06:50:19 PM »
I know this won't be news for many of you, but you can cut the printing time in half or even less if you switch to a bigger nozzle. I went from a 0.4 to a 0.8 on my ender 3.

Even though I slowed things down to 30-50 mm/s I managed to get the top part printed in about an hour, the base takes around 3 h. I went to a layer height of 0.3 but I think you could even go to 0.4 without much issue.
The inside looks a bit rougher, but everything still fits.

In addition, my top parts have been more consistent this way because my printbed is not 100% level.

Pages: 1

SMF spam blocked by CleanTalk