News

moodlite - Coming soon


Recent Posts

1
Hello I am also using an ender 3 and have a 22 tile setup.
You can print full size, just rotate the pice slightly and you can make it, also make sure you dont have so skirts stealing your building capacity, I strongly recommend it, otherwise you will have problems fitting the servo cable connectors.
Also for experience I prefer using a 2mm brimm, it hepls prevent warping on big models like this; with PLA is not a big issue, but I have had some on the corners of this project.

About loosing 1 print, don't worry, we all have gone through it.

https://moodlite.co.uk/index.php?topic=100.0
2
moodlite Chitchat / Re: Brightness and speed control not working
« Last post by 3dprinterman on August 17, 2019, 03:02:59 PM »
nope that did not work still cannot turn display off may go back to v2
3
moodlite Chitchat / Re: Brightness and speed control not working
« Last post by ARN on August 17, 2019, 02:14:09 AM »
Try using chrome in incognito mode from a PC, it let me use almost all the functions.
Use NTP and set it a modest time to work, 18:00 - 23:00 in my case.
Is not perfect but at least it lets me enjoy it, set as default works this way, at least for me.
4
moodlite Chitchat / Re: Brightness and speed control not working
« Last post by 3dprinterman on August 16, 2019, 07:26:13 PM »
yep same here Save as default" doesnt work.. manual display so cannot turn off only thing thats saves is the colours, patterns, fixed patterns, hope they can fix as its no good without being able to turn it off
5
9 hours later and I found that I printed it up side down  :-[ :-[ :-[

In Cura I needed to flip the STI over, printing again lets see what happens in 9 hours time.
6
moodlite Chitchat / what is the latest thoughts? 1, 2 or 3 LEDs per corner
« Last post by bertybassett on August 14, 2019, 07:33:38 PM »
What is everyone using?  I really only want 1 power lead and  20 to 25 tiles at max???  Worried about the servo wire amp limits
7
moodlite Chitchat / Re: Attaching Them Together
« Last post by bertybassett on August 14, 2019, 07:22:51 PM »
Your STI files on thingverse look much easier to print vs the official tiles.  Did you get around to printing them?
8
looks like I managed to make it fit by squeezing a few more mm from the bed. :-\ :-\ :-\
9
looks like I am going to have to reduce the size by 3% because my print bed is too small?  Do you think this will be an issue?
10
Anyone got any good recommendations for printing on a Ender 3 using Cura 4.2?  I am using the stock settings and PLA and get good results with the Benchy boat.

Hoping to get good results not he moodlites too.


SMF spam blocked by CleanTalk