News

moodlite - Coming soon


My new toy - JGAURORA A5

DevilsDJ · 201

DevilsDJ

  • Newbie
  • *
    • Posts: 25
    • Likes: +1/-0
    • View Profile
on: February 16, 2019, 09:45:55 PM
Got my new toy yesterday , Ill be testing it out for a while to see if it wil permanently replace my Anet A8 or if it will get sold :D



CdRsKuLL

  • The Fat Dude
  • Administrator
  • Full Member
  • *****
    • Posts: 110
    • Likes: +15/-0
  • Lighting the way...
    • View Profile
Reply #1 on: February 18, 2019, 09:24:01 PM
I have an A5 :-) Done loads of prints and its still working great.  You just need to be-careful of that bed, make sure you don't scratch it.. otherwise mines been a solid printer. Leaves a nice pattern on the moodlite tops too.




Moodlite is a completely free open source project.
If however you would like to say thanks and help contribute to this site, or just buy me a beer then please donate below. :-)



DevilsDJ

  • Newbie
  • *
    • Posts: 25
    • Likes: +1/-0
    • View Profile
Reply #2 on: February 19, 2019, 08:02:54 PM
Did you have problems with prints sticking to bed , so far 2 prints made - 2 prints had parts get lifted from bed , bed at 75C leveled as best as I can .



CdRsKuLL

  • The Fat Dude
  • Administrator
  • Full Member
  • *****
    • Posts: 110
    • Likes: +15/-0
  • Lighting the way...
    • View Profile
Reply #3 on: February 19, 2019, 08:12:13 PM
I always give the bed a wipe with alcohol before each print. Sticks great then. :-)

Moodlite is a completely free open source project.
If however you would like to say thanks and help contribute to this site, or just buy me a beer then please donate below. :-)



ARN

  • Newbie
  • *
    • Posts: 12
    • Likes: +1/-0
    • View Profile
Reply #4 on: February 19, 2019, 11:48:32 PM
I always give the bed a wipe with alcohol before each print. Sticks great then. :-)

Agree on the bed cleaning on each print.
22 successful panels using hatchbox 1.75 white pla
70c bed
room temp usually 30c but interestingly the best results were with room 27c over night, maybe the fresher air helped the pla to harden better.



 


SMF spam blocked by CleanTalk