News

moodlite - Coming soon


Issue with V3 only 3 LEDS

marky · 273

marky

  • Newbie
  • *
    • Posts: 12
    • Likes: +1/-0
    • View Profile
on: May 16, 2019, 01:51:50 AM
So as many have sayd we having issue with the new frimware.
Iv try changing the code to have it set to the number of leds I have I think I would have to set it in the eeprom for it to work. not sure how.
also try with different set of  led. only possible other problem would be the board il try that later.



SimonSplat

  • Newbie
  • *
    • Posts: 3
    • Likes: +0/-0
    • View Profile
Reply #1 on: June 05, 2019, 02:39:22 PM
I had this issue but managed to fix it by changing the following code:

Code: [Select]

// --- Uncomment to reset ---
// Erase EEPROM
//eraseEEPROM();
// Erase SPIFFS
//eraseSPIFFS();

to

Code: [Select]
// --- Uncomment to reset ---
// Erase EEPROM
eraseEEPROM();
// Erase SPIFFS
eraseSPIFFS();

Then uploading both the firmware (Upload button) and then the SPIFFS/Sketch (Tools -> ESP8266 Sketch Data Upload)

After setting the code BACK to the original (with the lines commented out as in the first code excerpt) re-uploading both firmware and SPIFFS/Sketch as above.

I had both the USB plugged in as well as the DC power (not sure this makes any difference) and after doing the wifi settings can change the config in the web interface and the values persist and can use more than 1 tile/3 LED's

YMMV!

SimonSplat



 


SMF spam blocked by CleanTalk