News

moodlite - Coming soon


Any good recommendations for printing on a Ender 3 using Cura 4.2.1

bertybassett · 58

bertybassett

  • Newbie
  • *
    • Posts: 6
    • Likes: +0/-0
    • View Profile
Anyone got any good recommendations for printing on a Ender 3 using Cura 4.2?  I am using the stock settings and PLA and get good results with the Benchy boat.

Hoping to get good results not he moodlites too.




bertybassett

  • Newbie
  • *
    • Posts: 6
    • Likes: +0/-0
    • View Profile
looks like I am going to have to reduce the size by 3% because my print bed is too small?  Do you think this will be an issue?



bertybassett

  • Newbie
  • *
    • Posts: 6
    • Likes: +0/-0
    • View Profile
looks like I managed to make it fit by squeezing a few more mm from the bed. :-\ :-\ :-\



bertybassett

  • Newbie
  • *
    • Posts: 6
    • Likes: +0/-0
    • View Profile
9 hours later and I found that I printed it up side down  :-[ :-[ :-[

In Cura I needed to flip the STI over, printing again lets see what happens in 9 hours time.



ARN

  • Newbie
  • *
    • Posts: 19
    • Likes: +4/-0
    • View Profile
Hello I am also using an ender 3 and have a 22 tile setup.
You can print full size, just rotate the pice slightly and you can make it, also make sure you dont have so skirts stealing your building capacity, I strongly recommend it, otherwise you will have problems fitting the servo cable connectors.
Also for experience I prefer using a 2mm brimm, it hepls prevent warping on big models like this; with PLA is not a big issue, but I have had some on the corners of this project.

About loosing 1 print, don't worry, we all have gone through it.

https://moodlite.co.uk/index.php?topic=100.0



 


SMF spam blocked by CleanTalk