moodlite - Coming soon

Building a Prusa MK3 Clone...

CdRsKuLL · 2479


  • Newbie
  • *
    • Posts: 2
    • Likes: +0/-0
    • View Profile
Reply #45 on: May 15, 2019, 03:30:57 AM
Tnx for the repply. I notice when i upload your Firmware when it do the selftest i get the error that the Front Fan isn't spinning, but it is :/ and i can't continue the wizzard. I notice this on original Firmwares from prusa too. Just one (i don't remember the version..i think it's 1.5.0 or something) that the fan test was ok. When did you buy ensy board u just upload the Latest Firmware from prusa and the wizzard worked? Or u have the same problem? I order now ensy board from Amazon..i asume it's the board problem.


  • The Fat Dude
  • Administrator
  • Full Member
  • *****
    • Posts: 112
    • Likes: +15/-0
  • Lighting the way...
    • View Profile
Reply #46 on: May 15, 2019, 06:23:39 AM
Hi, yes it asks if the fan is spinning.. BUT it first asks you if the extruder fan is spinning which you answer NO, then it asks you if the front fan is spinning and you answer YES. I'm guessing you answered YES to the first question and it failed.

The firmware was only compiled a couple of days ago and I the very latest one. 3.7.1

Give it another go answering correctly and let me know :-)



Moodlite is a completely free open source project.
If however you would like to say thanks and help contribute to this site, or just buy me a beer then please donate below. :-)


SMF spam blocked by CleanTalk